Chute Cable, 240 In. / 20 Ft. Silver Jacket Clip Type, 3" Of Travel. cut To Desired Finish Length
PROFORMANCE PROS | Part# CHS-C91-240
In Stock
Highlights:
- Product specifications:
- Grooved housing for Clip Type mounting on one end
- 10-32 NF threaded rod on one end
- Exposed 0.075" diameter solid stainless wire on one end
- Provides a total of 3" of travel
- Flexible housing measures only .325" outside diameter
- Cable length is measured tip to tip
- Solid wire core
- Popular uses include:
- Parachute Releases
- Shutoff Valves
- Remote Battery Switches
- Guillotine Air Shut Off
CLIP TYPE CHUTE CABLE, 240 in. / 20 ft. MORSE CLIP TYPE, EPOSED 0.075" DIA. WIRE ON ONE END, EACH
$87.99
CHS-C91-240
The Chassis Shop
CLIP TYPE CHUTE CABLE, 240 in. / 20 ft. MORSE CLIP TYPE, EPOSED 0.075" DIA. WIRE ON ONE END, EACH
The Silver Jacket Premium 33 series parachute cable comes in the trademark silver color - that will compliment any paint color scheme.
Product specifications:
- Grooved housing for Clip Type mounting on one end
- 10-32 NF threaded rod on one end
- Exposed 0.075" diameter solid stainless wire on one end
- Provides a total of 3" of travel
- Flexible housing measures only .325" outside diameter
- Cable length is measured tip to tip
- Solid wire core
Popular uses include:
- Parachute Releases
- Shutoff Valves
- Remote Battery Switches
- Guillotine Air Shut Off
Cable Overview:
The solid wire core cable is desirable in certain applications such as a chute release, or when attachment hardware dictates a wire end.
Two sizes are available to choose from, the final overall length may be altered by cutting the exposed wire end if needed.
Fitted with efficient dynamic seals and requiring very little effort; these lightweight cables have a full circle of reinforcement wires to protect and support the inner liner, influencing positive load transfer with minimal lost motion.
Ideal for any cable operated application that requires pushing or pulling, and very well suited for extreme use environments. This combination should be considered as an upgrade replacement for Teleflex Morse type cables.
Grooved housing on one end, conduit on the other end.
Rated at 50# pull and 40# push, intermittent loads may exceed these ratings considerably without failure. These recommended load ratings reflect a balance between maximum load and reasonable cable life.
These aren’t a flimsy garden equipment control cable that will let you down when you need it the most.
Measuring Tip: To determine the proper length for your application, measure the tip-to-tip cable length by using a flexible rule to snake through the actual intended cable route.
For additional information, watch the Video below to see all the Silver Jacket Cables in action !
The Pro-Werks’ Silver Jacket Cables are proudly Made in the USA.
Categorized under:
